| | Bell Canada Dial 0
I downloaded your EasyDialer application today from AppWorld (as your callingcardDialer.com seems to be down)
I've been able to set it up to dial the Bell Canada access 1-800 number, the language preference (1 for english), the calling card number and PIN, and finally the contact phone number.
The problem is my Rogers bill will only show the Bell Canada access 1-800 number as who I dialed, and I require it to show the number of who I was calling.
Is there any way to setup my Bold, using your EasyDialer, so that it will dial 0, the contact phone number, then wait (or pauses) until the Bell Canada computer asks for the language (1 for english) then call type (7 for calling card), and finally the calling card number and PIN? This way my Rogers bill would show the actual number dialed, and that it was calling card call.
Last edited by kylet : 04-28-2009 at 04:40 PM.