View Single Post
Old 05-24-2013, 12:52 PM   #10 (permalink)
sting
New Member
 
Join Date: Aug 2009
Model: 8220
PIN: N/A
Carrier: rogers
Posts: 11
Post Thanks: 0
Thanked 0 Times in 0 Posts
Default Re: hub management not working - can't turn off

Quote:
Originally Posted by Toddmmmmm View Post

Anyone got a solution to this yet?

I have the Q10 which did some of the things mentioned above in this thread. I have since figured out that if you make the changes then "restart the hub", the changes take effect.

To restart the Hub on a Q10 do the following:

1. Bring up the hub screen

2. From the upper right corner drag your thumb diagonal to the center of the screen from there change direction and move your thumb straight up to the top center of the screen and remove thumb. This is done as one continuous motion!

3. Do the action described (in #2) 4 consecutive times and your screen will say "restarting Hub", once that pops up you have finished. The restart takes about 5 seconds.

Hope that helps, I'm not sure if the restart procedure works on the Z10 as I've never tried it? One of my coworker restarts his Z10 by tapping on the hub screen 5 times in a row, so perhaps try that?

Good luck

Last edited by sting : 05-24-2013 at 12:53 PM. Reason: spelling error
Offline   Reply With Quote