I tried to do this.. but I ended up putting too much solder on the pins. They are very close to each other... and the solder is not separated out enough. In other words the solder is all over the pins and there isn't space between them, so its all connected (not good).
It was really difficult to position the USB port's pins right over where they belonged and them have them touch.
I will try to take the usb port out again and try to clean up the solder, and try it again.
btw I made a video of the whole process.. it seemed to have been working for a second, then stopped then I messed it up a little bit more. I'll put the video up tomorrow on youtube.
I luvs my crackberry.. I think me Iz addicted
Last edited by azee1v1 : 01-08-2007 at 12:34 AM.