View Single Post
Old 07-01-2008, 07:30 PM   #4 (permalink)
JLUTHER
New Member
 
Join Date: Jul 2008
Model: 8100
PIN: N/A
Carrier: ATT
Posts: 5
Post Thanks: 0
Thanked 0 Times in 0 Posts
Default

No such luck. It fails during the "wait for device initialization" phase-- following erasure, the red LED starts flashing again, and when the LED is off, it apparently disconnects the port, opening it again when it turns red. This on again, off again connection isn't good enough for reinstallation, and eventually an "unable to reconnect to the device during a multi-stage load operation" error message appears. Actually, on one occasion, I was able to do an OS reinstall, but at the end of the reinstall, I was back where I started with the brick with the flashing red eye instead of the ATT logo followed by a screen of icons.
Offline   Reply With Quote