I was hoping to get some guidance on replacing the camera for the curve. Actually what I'm doing is moving the working camera from one curve to another.

More details on my situation...I had a 3810 that got slightly wet, and fried the board (turns on but no keys/buttons work, only the trackball). I did the full tear down to open it up but no luck. I have an old 3800 with a bad camera (ie...you try to start up the camera and it gives close apps message).

My thought is to move the camera from the 3810 to the 3800. I've tried to slightly pull it out with no luck. Before I get out the pry bar I thought I'd check in hear first to see if it's possible, or has been done before.

Thanks in advance for any help!