On the mini usb part of the PB (port), there is the little 'male' the connects to the 'female' part of the usb side of the cable, well the 'male' piece broke off on the PB port. I see 4 contact points in PB only. I hope I am clear.
Before you get your hopes up too high, just pointing out that this forum isn't associated with Research In Motion. It is privately owned and staffed by volunteers.
Just in case you thought this was a RIM operated forum
Thanks . Remember as NJ stated we are all just users of the forum site and make suggestions based on either our experience or from reading others suggestions posted here and on pother sites.
Ok so now that the problems seems to be the mini usb connector on the PB , if your good at working on electronics you may be able to replace the connector yourself. Do a Google search on the internet and you will se a few YouTube postings that can lead you in a direction needed. It will require use of a soldering iron and extreme caution in the disassembly but it seems doable.
If your unable to do the repair your only solution is to send it for repair to a company doing such.
__________________ If someone helps, tell them by clicking the Thanks button.!! î
9810 BES Z10 on BES 9700 BIS
The Following User Says Thank You to tsac For This Useful Post: