4S 40A Li-ion Lithium 18650 Battery PCB Protection Board Standard version FO For Sale
This item has been shown 4 times.
4S 40A Li-ion Lithium 18650 Battery PCB Protection Board Standard version FO:
Integrated 10 low load resistance MOS tube, continuous discharge 40A, 100mA balanced current, for electric drill/sprayer/ LED lights/low power inverter.
4S 16.8V 40A lithium battery protection board (comes with recovery function-AUTO Recovery)
Scope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650, polymer lithium battery)
Charging voltage: 16.8V - 18.1V
Continuous discharge current (upper limit): 40A (if the cooling environment is not good, please reduce the load current use)
Continuous charge current (upper limit): 20A
Standard version: suitable for starting current below 60A, power 100W below the drill.(Not balanced function)
Note 1: The successful start of the drill requires three 15C-20C power battery, or six 10C-15C power battery (ordinary 18650 can not start the drill!!).
Note 2: strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
Note 3: When the load of the brush motor is used, try to connect a non-polar capacitor (withstand voltage above 25V, capacity 10uF-100uF) to the motor's positive and negative terminals to prevent the reverse spike from the motor. Break the MOS tube.
Note 4: 4 groups of batteries in series, please ensure that the voltage of each group of batteries, if not the same, please fill each battery separately and then use in series. The The Discharge test, the voltage drop faster battery that group is poor battery.
Rotary Encoder Module Brick Sensor Development Audio Potentiometer Knob C Ae
Grass Instrument Co. 7p10b Polygraph Integrator
Crocodile Clamp Wire To Female Usb Connector Test Leads Copper Alligator S2u
Gardner Bender Psm-1550t Plastic Clip On Cable Staple, 1/2"