Bunn - TITAN-TF-0001 - Titan™ 3 Gallon ThermoFresh® Coffee Server For Sale
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Bunn - TITAN-TF-0001 - Titan™ 3 Gallon ThermoFresh® Coffee Server:
$169.00
Bunn - TITAN-TF-0001 - Titan™ 3 Gallon ThermoFresh® Coffee Server
Used coffee server in good conditions. A few scratches and minor dents here and there but still in good working condition.
Any questions you may have, please just ask!!As usual.....
Titan TF ServerInsulated to keep coffee hot & fresh for hoursContemporary stylingWrap around program available for merchandisingHigh faucet clearance allows for cups, decanters &carafesBrew through lid Sight gauge INTRODUCTION This server is intended for use with a BUNN® TITAN DUAL, or TITAN SINGLE coffee brewer only. When proper precautions are followed, 1.5 to 3.0 gallons of coffee may be brewed directly into the server and then transported to a remote serving location. The server must be placed on a sturdy counter or shelf. USER NOTICES The notices on this server should be kept in good condition. Replace unreadable or damaged labels. DAILY CLEANING CAUTION: CLEAN AND SANITIZE YOUR SERVER DAILY NOTE: Bunn-O-Matic recommends the three step method for cleaning and santizing the server. The 3 step method consists of hot soapy water using an mild, non-citrus detergent, a fresh water rinse and an aqueous sanitizing solution using a non-chlorine sanitizer. Do not submerge the server. Failure to follow the recommended cleaning procedures can cause corrosion to the stainless steel surface and damage the vacuum seal. USE OF ANY CHLORINATED PRODUCT VOIDS THE FACTORY WARRANTY. 1. Run a complete brew cycle of just hot water into the server and let it set for a minute. Empty the server completely by opening the faucet. 2. Remove the lid, fill server with cleaning solution and thoroughly clean the inside of server. 3. Rinse server thoroughly using fresh water rinse. 4. Fully fill server with sanitizing solution for 5 minutes then drain through fully open faucet. 5. Remove the faucet handle/stem assembly by unscrewing the faucet nut just behind the faucet handle. 6. Use enclosed cleaning brush to thoroughly clean the faucet spout and connector. 7. Remove the cap, sight gauge tube and washers. 8. Use enclosed cleaning brush to thoroughly clean the fill tube of the lid assembly and sight gauge tube. 9. Disassemble the faucet/stem assembly. Thoroughly wash all faucet parts and lid in a mild detergent and water solution. Rinse the parts in hot water. Sanitize the parts for five minutes, then air dry completely. 10. Reassemble the faucet/stem assembly and attach it to the faucet. When reassembling - CAUTION: DO NOT over-tighten faucet wing nut or faucet bonnet - HAND TIGHTEN ONLY. 11. Install the sight gauge tube and washers in the shroud and secure with the shroud cap. 12. Clean the entire outside surface of the server using a clean SOFT, Non-abrasive cloth dampened with any mild, non-citrus, non-abrasive, liquid detergent. 13. Thoroughly rinse the entire server after cleaning
Related Items:
Bunn 38894.0001 Switch/Breaker On-Off 125/250V 50A
$49.99
Bunn Funnel Ay, W/Decal Grt "C" 8.70 34559.0003 - Geniune OEM
$80.00
Bunn 12950.0443 WTF15-TC PF Coffee Brewer--GOOD WORKING CONDITION
$250.00
