GE-Fanuc IC694ALG392 Output Module For Sale

GE-Fanuc IC694ALG392 Output Module
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Buy Now

GE-Fanuc IC694ALG392 Output Module:
$775.00

The GE Fanuc IC694ALG442 is an Analog Combination Current/Voltage Input/Output Module for Rx3i PacSystems.This module provides four distinct input channels and two single-ended output channels. Each channel can be configured using Machine Edition software in any of the following ranges: (0 to +10) unipolar, (-10 to +10 volts) bipolar, 0 to 20 mA, or 4 to 20 mA. The 0 to +10 unipolar range is the default setting for the system and will be automatic upon installation unless altered. In a higher mode, the input channels can be configured for a 4 to 20 mA range. The IC694ALG442 can be used in any I/O slot within the Rx3i system.

Various outputs can be configured. A Hold Last State is possible if the system power is interrupted or can be reset to the low end of the given series. Outputs may also be configured to run in ramp mode on command from the applicable program. Additionally, low and high alarm ranges can be set for all input channels with an open wire fault relayed to the CPU for each output channel.

ThisIC694ALG442module must be attached to a 24 VDC power from an outside source for proper use. If used with the RX3i Universal Backplane, the external source can be attached through the TB1 connector located on the left hand side of the backplane. Another option is available through a direct connection on the module’s terminal block. If using the backplane, the external source must be connected to the terminal block. Resolution per bit is based on the configured input or the output range. If the current source is reversed into input, or if it is below the low end of the current range, the module inputs a data word equivalent to the low end of the range. Resolution of the translated signal is 12 binary bits from the A/D converter in the %AI. Each channel is capable of 15 to 16 bit converting.

As a bonus feature, IC694ALG442 can respond directly to specific COMMREQ commands from the application program for certain tasks, such as removing the error code, amending input alarm limits, and putting one or both outputs into ramp mode.



Buy Now

Related Items:

GE-Fanuc IC694ALG392 Output Module picture

GE-Fanuc IC694ALG392 Output Module

$775.00



GE Fanuc IC694ALG392A Analog Output picture

GE Fanuc IC694ALG392A Analog Output

$299.00



1pcs Brand New ones GE Fanuc IC694ALG392 Analog Output Module picture

1pcs Brand New ones GE Fanuc IC694ALG392 Analog Output Module

$714.03



Popular Forums