Blk Bezel and Feedback
 

ok

i just did a test and and can confirm that u need to transfer the top and bottom mesh from original silver bezel or else you will have feedback when using speaker fon.

i test my bold with blk bezel and no mesh = feedback

bold with blk bezel and mesh = no feed back



hope this helps...not sure if this was discovered before

I didnt transfer the top only the bottom and have no feedback

this has been covered in many many other threads. yes without the mesh you will get the feedback.

I'm experiencing feedback and I didn't change my bezel. Software problem maybe?

Dunno, maybe each phone is different? I did the bezel change and neglected to move the screens over for several days. I didn't have any feedback whatsoever.

i dont have feedback without the mesh either.

Didn't transfer mesh here and no feedback.

I am still not brave enough to try this........But it looks good

How did you get the top mesh off without destroying it?

i used a pin to push one side loose and than slowly peeled it off with a pair of tweezers.

That is what I tried, the pin went through the mesh, when I tried the peel it with the tweezers the mesh just ripped. The bottom mesh came of fairly easily though.

I guess if I find i need it I will just order an original bezel and try again.

thanks

I've been wondering how the black bezel does with scratching, I've heard some say that a scratch will reveal the original silver underneath, while others say scratches aren't noticeable and only show black plastic.
Anyone have any experience or comments with this?

I haven't had any issues with the black bezel!!