Low Noise Amplifier, 800 to 1100MHz, Room Temp to Cryogenic, 25dB Gain(nom.),SMA For Sale

Low Noise Amplifier, 800 to 1100MHz, Room Temp to Cryogenic, 25dB Gain(nom.),SMA


Buy Now

Low Noise Amplifier, 800 to 1100MHz, Room Temp to Cryogenic, 25dB Gain(nom.),SMA:
$6.99


Order two or more and save.
Gain bandwidth is wider, but my spec is for the more rigorous condition of VSWR matching with S11<-15 dB. This is met at room temperature approximately from 810 MHz to 1,100 MHz and at 77K approximately from 800 MHz to 1,000 MHz. I am not sure of the bandwidth for minimum noise, but it is probably about 810 MHz to 860 MHz.
The VNA sweeps are for one representative LNA. Not necessarily the best piece, rather the only one that I swept the day I took the pictures. I have used all of them and they were all made to the same spec. Nevertheless, for this price, you are accepting the possibility of performance variations.Buyer is responsible for reviewing the VNA sweeps and forming their own opinion of the likely S-parameter performance.
This LNA was made using hard substrate so that it can also be used at cryogenic temperatures. In fact it performs well from room temperature down to cryogenic, in air and in vacuum. Very low outgassing. Designed for high vacuum operation.Lower operating temperature limit is unknown. I have used these down to 25 Kelvin. I have never taken them above 320 Kelvin (47 Celsius).Manufacturer logo was not imprinted due to the vacuum specification.SMA (f) connectors mounted on a 23 mm x 25 mm x 9 mm housing. 50 Ohm.Bias at +5 VDC and 0.073 A. You can bias as low as 2.5 Volts if you need even lower heat load. These VNA sweeps used a 2.5 V bias which drew only 68 mA. No heat sink needed with this LNA.
I have attached a Zener diode across the bias terminals so it is already electric shock resistant. (The Zener leads might be coated with GE varnish for electrical insulation.)
Noise Figure at 77K is <0.5 dB. I once measured the noise figure versus temperature for one of them. The attached graph is a representative sample from the large lot that I once owned, and is not guaranteed to be exactly the same as the piece that you receive. Noise figure was measured at 5.0 VDC bias.
1 dB compression point is about +5 dBm to +10 dBm at the output. I measured P1dB=-19 dBm at the input for the unit in the photos.My memory says the IP3 is about +15 dBm to +20 dBm at the output. Again, this is not guaranteed.
I have decided to no longer list this item for international sales. Sorry for any inconvenience.


Buy Now

Related Items:

RF Amplifier, Low Noise LNA 50 to 4000MHz SPF5189Z RF Amplifier for AmplifyingI2 picture

RF Amplifier, Low Noise LNA 50 to 4000MHz SPF5189Z RF Amplifier for AmplifyingI2

$9.99



775 DC 12V-36V 3500-9000RPM Motor Ball Bearing Large Torque High Power Low Noise picture

775 DC 12V-36V 3500-9000RPM Motor Ball Bearing Large Torque High Power Low Noise

$15.03



10PCS TL072IP TL072 Low Noise JFET Dual Op-Amp DIP-8 New IC picture

10PCS TL072IP TL072 Low Noise JFET Dual Op-Amp DIP-8 New IC

$11.98



Popular Forums