Product works and I used a handful of times. Hooked it up and had no leaks and it seems to be great for a diy person. Cuts through 1/4 inch pretty descent haven't tried any thicker. Includes everything needed to use, had to get a fitting for compressor hook up, cost 5 $. Time will tell but perfect so far. Allows cuts an angle grinder won't do.
Verified purchase: Yes | Condition: New
I honestly could not give this unit of bad review. I just think I got one with a defective part in it. I would love to have another one just like it that work like it should. The cut 50 actually works very well for the purpose I used it for which is making yard art out of old Freon tanks. It cut effortlessly and did a very good job. Sometimes it would not arc like it should and I would actually have to cut the machine off and then back on and it worked fine. Then one time I cut the machine on and it kicked the breaker and it is never work since that time. That was about a week after I got it.
Verified purchase: Yes | Condition: New
I've used it for a couple weeks so far and so far so good! For the money, it's a great value. If I can get a couple years + out of it, I'll be very satisfied. I've used it to cut/repair the frame of a TJ Jeep Wrangler and it cuts through pretty good. The thickest metal I've tested it on is about 1/4" steel and it did a pretty decent cut. If you can't afford the $$ of the big named brands then this is the way to go.
Verified purchase: Yes | Condition: New
First time plasma cutter user. I love this thing! bought it for sheet metal work and it does it extremely well! My only complaints are it is a 220 unit with only a 110 plug.. And the hose clamps are garbage! But all in all for $170 its unbeatable!
Verified purchase: Yes | Condition: New
I have no prior experience with a plasma cutter. It took maybe 20 minutes to get it put together and set up. I have tried it on thin gauge steel and copper and a up to about 1/8 inch steel. The thin gauge cuts very quickly and fairly clean. The thicker took some time, but made the cut. It does what it is supposed to. I was using it at 120 volts, but have read it will perform better at 240, so will be wiring it with a dual plug so I can use it at 120 or 240. I have no idea how long this will last. I am guessing for a casual user like me it will last forever. Time will tell. Be forewarned that a regular welding helmet will probably be too dark. I could not see the line. I purchased brazing goggles with a #5 darkness. Do your own research to decide how dark you want. I would recommend this plasma cutter. Read full review
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Plasma Cutters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Plasma Cutters