BlackBerry Forums Support Community

BlackBerry Forums Support Community (http://www.blackberryforums.com/index.php)
-   General 9800 Series Discussion - Torch (http://www.blackberryforums.com/forumdisplay.php?f=142)
-   -   **problem** screen saver shadows from case magnet (http://www.blackberryforums.com/showthread.php?t=241535)

Jelly Bean 12-11-2010 04:08 PM

**problem** screen saver shadows from case magnet
 
:x

New Torch from ATT, using the ATT case and ATT protector

Two days after getting phone, I had this round circle shadow impression on the film of the screen protector, thought it was the screen. The case of course being new is tight, but once I took off the protector at ATT, it was revealed that the screen was OK. Tech said they had never seen this before, even kept back the screen protector to show others the shadow created. One tech said to then turn it inside out(facing back of case toward body) in the case with the newly applied screen protector to protect the screen more, another said to do it all over again front side out to see if it happens again with the new screen protector. They did give me a new case, just in case the "case" was defective. Well its happening again. Before I go back into ATT, Id like to trouble shoot this with you all.

What is happening?
Is this typical? This is the first touch screen device for me, and first screen protector ( i took protectors off my last three BB devices.)

The case is: AGF Premium Leather Case ATT for $39.99 G003773R00

The screen protector is: Anti fingerprint, Anti glare full face protection by case mate from ATT 2 for $19.99

thank you, and advisement would be great

Jelly Bean 12-11-2010 04:13 PM

Re: **problem** screen saver shadows from case magnet
 
oh, could the phone be running too hot in a too tight case to create this shadow efect of the magnet on the case?

JimScar 12-14-2010 06:52 PM

Re: **problem** screen saver shadows from case magnet
 
Perhaps... water-based leather dye slightly staining the protector. The "plastic" protector will be far more porous (microscopically) than the glass face of the capacitive Torch screen. You could try putting a thin layer between the protector and the leather (Saran wrap?). Or getting a new case.

Water-based dyes give leather a much deeper, darker look and are easier and cheaper to use. Any significant moisture, even high humidity, could cause the dye to leach. If the phone or screen is warm, it would increase the possibility.

Jelly Bean 12-18-2010 11:53 PM

Re: **problem** screen saver shadows from case magnet
 
thank you for this input. I took the phone back in to ATT and they went ahead and swaped to a different brand case, and placed another new screen protector on. The dye very well could be what was creating this...hopefully with this other maker, it will be ok now. Thank you

Sytner 12-19-2010 10:06 AM

Re: **problem** screen saver shadows from case magnet
 
Whatever solution they apply to the protector to give it fingerprint protection could also be being faded/marked by the dyes.


All times are GMT -5. The time now is 09:46 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.