BlackBerry Forums Support Community - View Single Post

youngdoc · 03-10-2009, 03:54 PM

I have adjusted the screws as well. Mine required a T6 -- the T7 was too large. I turned a little more than 1/2 turn each. Typing is MUCH more fluid now. Note that you should test the screen click AFTER you have put the back (and any case you use) back on your Storm. The additional tension created by the back of the device and a tight fitting case will influence your screen click. Since I just made the adjustment today, I will post again if I notice any changes down the line.

03-10-2009, 03:54 PM	#45
youngdoc New Member Join Date: Feb 2009 Model: Storm PIN: N/A Carrier: Verizon Posts: 5	I have adjusted the screws as well. Mine required a T6 -- the T7 was too large. I turned a little more than 1/2 turn each. Typing is MUCH more fluid now. Note that you should test the screen click AFTER you have put the back (and any case you use) back on your Storm. The additional tension created by the back of the device and a tight fitting case will influence your screen click. Since I just made the adjustment today, I will post again if I notice any changes down the line.
Offline